Configuration
Rev 3.01 24 Document 900.0258
10/05
Note It is the user's responsibility to determine if local laws and
regulations permit recording audio.
5. Highlight the box beside Sequence Dwell Time and select from 3 to 60 seconds
for the camera sequence dwell time.
• Selecting System Information… enters a screen that allows you to set the site
name, set the language, and view various system operational parameters.
• Selecting Storage Check… enters a screen where you can check the storage
status.
Note The Storage Check and Date/Time options may be greyed out
(cannot be selected) if Quick Setup has just been enabled. To
access these options, press MENU to exit the menu, then press
it again to re-open the Quick Setup screen, with all options
available.
• Selecting Camera… enters a screen where you can set up camera information.
• Selecting Network Setup… enters a screen where you can set up network
information.
• Selecting Password… enters a screen where you will be able to change
passwords.
• Selecting Date/Time… enters a screen where you will be able to set the DVR time
and date.
• Selecting System Shutdown… shuts the DVR down. When shutting down the
DVR, you need to confirm that you want to shut down the unit, you will be asked
for an administrator password.
Note The Quick Setup mode releases automatically when the user
changes the DVR settings remotely using the RAS (Remote
Administration System) program.
To Next Page
Loading...
