Honeywell IDENT KEY 3 User Manual

23Operating Manual IK3 Operating Unit with Keypad
8.2 Disarm
The type of disarming is defined in the programming of the central control unit/EU. Optical and
acoustical acknowledgement is identical after an action has been performed.
Acknowledgement:
1. Activate key (Quick)
2. Only IK data carrier
3. Only PIN
4. With IK data carrier and PIN
With PIN and IK data carrier
Activate the "disarm" key, acknowledgement
follows
Activate the "disarm" key
Hold the IK data carrier in the reading range,
acknowledgement follows
Activate the "disarm" key
Enter PIN, acknowledgement follows
Activate the “disarm” key
Hold the IK data carrier in the reading range,
"Ready” flashes 1x
(if no authorization, negative acknowledgement)
Enter PIN, acknowledgement follows
Activate the "disarm" key
Enter PIN, "Ready" flashes 1x
(if no authorization, negative acknowledgement)
Hold IK data carrier in the reading range,
acknowledgement follows
0....9
0....9
0....9
IK-D
IK-D
IK-D
Fulfilled with authorization
and positive drive
System is disarmed
No authorization
No positive drive
Alarm
(red)
Disarmed
(yellow)
Ready
(green)
Acoustical
(signal)
Positive acknowledge.
Negative acknowledg.
Negative acknowledg.
Lights up in case
of alarm
Optical
Action
System is disarmednot System is disarmednot
5 sec. 5 sec.
Lights up in case
of alarm
2 sec.
Dis-
armed
Armed
or

Honeywell IDENT KEY 3 Specifications

General

Brand	Honeywell
Model	IDENT KEY 3
Category	Control Unit
Language	English