Honeywell IDENT KEY 3 User Manual

Start learn mode
Learn data carrier without index
Hold the IK learn master key in the reading range
Activate "OK"
The "Alarm" indicator lights up green
The actions can now be performed.
Hold new IK data carrier in the reading range
Activate "OK"
"Alarm" indicator flashes 1x
Hold old IK data carrier in the reading range
Activate "Delete”
"Alarm" indicator flashes 1x red
Enter new index
Activate "OK"
Hold new IK data carrier in the reading range
Activate "OK"
"Alarm" indicator flashes 1x
Enter index
Activate the "Delete” key
Enter index again
Activate the "Delete" key
"Alarm" indicator flashes 1x red
Activate "Delete" key
"Alarm" indicator goes off
Delete data carrier without index
Learn data carrier by index
Delete data carrier by index
Quit learn mode
27
Operating Manual IK3 Operating Unit with Keypad
Green
Green GreenRed
0....9
Green
Green GreenRed
0....9
0....9
IK-L
IK-D
IK-D
IK-D
3
3
r
3
3
r
r
r
8.7 Learn mode
Learn mode is used for the simple authorization of new data carriers or deleting already existing
ones.
In order to start and exit the learn mode, a is required. This so-called “learn
master key” is a data carrier that is defined exclusively in the system for this purpose.
As long as the learn mode is activated, any number of actions can be performed successively.
The "Alarm" indicator is used in the learn mode as an optical acknowledgement signal. It lights up
green, as long as the learn mode is activated. It flashes briefly to acknowledge an action that has
been performed.(s.b.).
The learn mode can only be activated in a
If an action cannot be performed, negative acknowledgement follows!
: The "Index" corresponds to the location in the memory (key number).
"Learn master key"
disarmed state.
Note

Honeywell IDENT KEY 3 Specifications

General

Brand	Honeywell
Model	IDENT KEY 3
Category	Control Unit
Language	English