Chapter 2 — Set Up the Printer
PD43 and PD43c Commercial Printer User Manual 45
11 Route the liner through the slot in the front door of the label
dispenser. Do not pull on the media to take up the slack. The liner
should be over the roller in the printer and under the roller in the
front door of the label dispenser.
12 Close the label dispenser front door.
13 Press the print mechanism down to lock it in place.
14 Close the media compartment door and then close the top of the
printer.
15 Press and hold for two seconds to begin a test feed. The printer
dispenses two labels at the front of the printer as it calibrates the
media feed.
16 If necessary, adjust media settings . You can also use the Main
Menu wizards to help calibrate the media feed and the label taken
sensor.
In the Main Menu, select Wizards > Calibration and then select
Media or Label Taken Sensor.
To Next Page
Loading...
