MeshGuard LEL IR & CO2 IR User’s Guide
18
Enter Detection Mode by turning the instrument on. Enter Programming Mode from Detection Mode
by holding down [MODE] and [N/-] together. To enter Diagnostic Mode, start with the MeshGuard
LEL IR turned off and hold both [Y/+] and [MODE] to start it. Once Diagnostic Mode is on, enter
Diagnostic Programming Mode by holding [N/-] and [MODE] together.
5.7. Detection Mode
Whenever you start MeshGuard LEL IR or MeshGuard CO2 IR by pressing and holding [MODE], it
is automatically in Detection Mode.
The instrument displays the current reading:
or
To Next Page
Loading...
