MeshGuard LEL IR & CO2 IR User’s Guide
22
5.9.1. Entering Programming Mode
To enter the Programming Mode, press [MODE] and [N/-] for 3 seconds while the instrument is on.
“Pro” appears in the display:
Pressing [N/-] steps you through all the screens and then returns to the first programming display:
Each display alternates between its name and a status message or value.
Note: You can exit Programming Mode at any time by pressing [MODE]. Also, if you do not make a
change within one minute, the instrument exits Programming Mode and returns to Detection Mode.
To Next Page
Loading...
