Honeywell miniMAX - Section 6: System Testing; Testing the System with the Default Configuration (Recommended)

Rev. 1.0 13 900.0688
9-Dec-05
SECTION 6:
SYSTEM TESTING
6.1 TESTING THE SYSTEM WITH THE DEFAULT CONFIGURATION
(RECOMMENDED)
Your miniMAX system computer has been loaded with a default configuration.
This configuration will provide switching of any camera to any monitor. It is
recommended that the system hardware be tested in this mode prior to editing the
system configuration using the SETMAX program. PTZ control is defined for camera
number 1 (set to address 1) for testing purposes.
1. To select a camera to a monitor;
Press the MON key, press the number of the monitor you require, and then press
the ENT (Enter) key.
2. After selecting the monitor, press the CAM key, press the number of the camera you
require, and then press the ENT (enter) key.
Further cameras can be selected to the same monitor by repeating step 2 (above), or by
using the up or down arrow keys
or