28
Enable Aztec Structure
Append Decoding
* Disable Aztec Structure
Append Decoding
³124416
³124406
When this feature is enabled, Aztec bar codes with a structured append header
will be stored in the imager’s memory buffer. The imager will transmit the
concatenated message once every component of the structured append bar
code has been read. Up to 16 components can be stored.
If this feature is disabled, Aztec bar codes with structured append header will be
read as normal Aztec bar codes. However, in this case, the structured append
header will be sent as part of the bar code data.
Notes: CodeSelect
®
and structured append features cannot be used
concurrently. If both CodeSelect and structured append are enabled,
CodeSelect feature will not work.
The CodeSelect timeout setting determines how much time will be
allowed between individual components of the same bar code
(similar to CodeSelect operation).
By default, the imager will emit an intermediate beep when each component is
scanned. When only one scan buffer is enabled, the user will be required to
release the trigger after reading each bar code component.
* Enable
Intermediate Beep
Disable
Intermediate Beep
³124405
³124415
Note: If the intermediate beep is disabled and the number of scan buffers is
increased (compare buffers in MetroSet2) – all components of a
structured append bar code can be read with a single trigger activation,
and only one audible beep will be produced, as if a regular bar code
was scanned.
*
Factory default configuration.
To Next Page
Loading...
