Chapter 3 - Plan and Install MLPLC
l Fiber Optic cable : Tx to Rx, Rx to Tx (Multi-mode FO, LC connector type)
The following image illustrates the ML200R architecture with dual I/O link redundancy.
Figure 16: ML200R architecture with dual I/O link redundancy
ATTENTION
The images illustrate the architecture of 2MLR-CPUH/T (Electrical). The architecture remains the
same for 2MLR-CPUH/F (optic fiber).
The following table describes the topology of ML200R.
Table 23: Topology of ML200R
- 39 -
To Next Page
Loading...
