l STOP mode
l DEBUG mode
ATTENTION
Refer to ML200 CPU and SoftMaster User’s Guide for further information about the module state
transition.
Changing operation mode
The following methods are used for changing the operation mode.
l Using the mode key of the CPU module.
l Using the programming tool (SoftMaster).
l Using SoftMaster to change the operation mode of a remote CPU module networked with the
main CPU.
l Using a networked SoftMaster, HMI and the computer link module.
l Using the ‘STOP’ command, while a program is operating.
WARNING
Changing the operation mode can energize the field and may cause serious injury to
the users.
Setting operation mode
The operation mode for ML200-IECcan is set as follows:
Operation Mode
Switch
Remote
Switch
SoftMaster
Command
Operation Mode
RUN X X Run
Stop On Run Remote Run
Stop Remote Stop
Debug Debug Run
Off Mode change Transfer (changed) operation
mode
RUN → STOP X - Stop
- 48 -
Chapter 3 - Plan and Install MLPLC
To Next Page
Loading...
Need help?
General
