2. Over current protection: If the current is more than the standard and flows in DC 5V, DC
24V circuit, the over current protection device shuts down the circuit to stop the system.
Remove the causes such as lack of current capacity or short circuits that leads to over
current and then restart the system.
3. Over voltage protection: The over voltage protection device shuts down the circuit to
stop the system, if the voltage is greater than the standard and is applied to the DC 5V
circuit
Power supplies for ML200R
ATTENTION
The main reason for using redundant power supply is that it has a component and the CPU
checks this component for the status of power failure. This component is not available in a non-
redundant power supply.
The following table provides the specifications of the power modules for ML200R.
1.3 Types of modules
The following are the different types of modules supported for ML200 IEC and ML200R.
l Input/Output module
l Special module
l Communication module
Input/Output module
The following table provides details about the different types of input and output modules.
Table 6: Types of I/O modules
- 5 -
Chapter 1 - Masterlogic components
To Next Page
Loading...
Need help?
General
