Honeywell Morley-IAS ZX2Se - National Approvals; En54 Information

MORLEY-IAS ZX Fire Alarm Control Panels
Page 2 Document No. 996-175-000-1, Revision 01 Commissioning Manual
CAUTION: A Lithium Battery is used for Data Retention.
Replace only with the same or equivalent type. Contact the Service Organisation for
Replacement.
This symbol identifies that the panel uses a safety isolating mains transformer.
1.3 National Approvals
This equipment must be installed and operated in accordance with these instructions and the
appropriate national, regional and local regulations specific to the country and location of the
installation. Consult with the appropriate Authority Having Jurisdiction (AHJ) for confirmation of the
requirements.
1.4 EN54 Information
EN54
!
EN54-2 13.7
Maximum of 512
sensors / manual
call points per
panel.
• The ZX1Se, ZX2Se, ZX5Se and ZX10Se range of panels has many
features, which if used inappropriately, may contravene the
requirements of EN54. Where such a possibility may arise, a suitable
warning is given with brief details of the EN54 requirement and the
relevant section it pertains to. A typical EN54 non-compliance
warning is illustrated.
EN54
9
• This Fire Control Panel complies with the requirements of EN54-2/4 1997. In addition
to the basic requirements of EN54, the panel conforms to the following optional
functions.
Option EN54-2 Clause
Indication: Fault signals from points
Controls: Coincidence Detection
Delays of Actioning Outputs
Disablement of each address point.
Test condition
Outputs: Outputs to fire alarm devices
8.3
7.12
7.11
9.5
10
7.8
EN54
9
• The power supplies for the ZX1Se, ZX2Se, ZX5Se and ZX10Se range of panels
complies with the following clauses of EN54-4.
Power Supply Functions EN54-4 Clause
Derive power supply from main power source
Derive power supply from a standby battery source
Charge and monitor the standby battery source
Detect & signal power supply faults
5.1
5.2
5.3
5.4