Configuring Messaging
Select the “Settings” tab and scroll down to “Pre-set message”.
The Messaging pane is shown. You can input up to 10 messages to be sent from the Wi-Fi-
equipped instrument.
After your Wi-Fi-equipped instrument has accepted the new settings, disconnect the USB cable
from the instrument and computer, and exit Communications Mode on the instrument by
pressing [Y/+].
Note: Your messages are limited to 20 characters each, including spaces and hyphens. Text is
automatically divided into lines at word spaces and hyphen characters. Therefore, you should
include word spaces or hyphens. Otherwise, it cannot create a new line when necessary.
Note: When you type a message, it will not accept more characters after you reach the 20-
character maximum.
When you are done making changes to the configuration for Wi-Fi and Messages, upload your
changes to your Wi-Fi-equipped instrument. Click the “Save” icon to send the new
settings to the instrument.
Honeywell MultiRAE Series™ 171 User Manual
To Next Page
Loading...
Need help?
General
