Honeywell MultiRAE Series User Manual

Important! The MultiRAE must have firmware version 1.50 or higher installed in order to enable
P2P switch functionality. If the instrument requires an upgrade, follow the MultiRAE Firmware
Upgrade Instructions in section 13. Otherwise, skip to the next section.
Enabling BLE
To enable these settings, connect the instrument to your PC running SSDC and from the Device
list page, click on the serial number of the instrument.
Click on “Settings” and scroll down to “Instrument User Preferences”. Click the box “Enable
BLE” and click SAVE.
NOTE: All the available licenses enabled are displayed in a list after the license is enabled.
NOTE: More than one key can be enabled and added. The license key can be added using
another instance of SSDC or same instance.
When you are done, press [Y/+] to exit the PC communications mode on the MultiRAE. The
instrument returns to operating in Normal mode.
Honeywell MultiRAE Series™ 177 User Manual

Honeywell MultiRAE Series Specifications

General

Brand	Honeywell
Model	MultiRAE Series
Category	Gas Detectors
Language	English