Honeywell MultiRAE Series - Page 45

195 pages

To Next Page

To Previous Page

Note: Refer to Honeywell Technical Note TN-190 for more information on how point-to-point

operation works.

Honeywell MultiRAE Series™ 40 User Manual

Main Page

Table of Contents2
Honeywell Multirae Series6
Safety6
Features Comparison13
Standard Contents16
General Information19
Key Features20
User Interface24
Display Overview24
Screen Display for Various Numbers of Active Sensors31
Menus32
Wireless Control and Submenus37
Point-To-Point Wired Connection40
Using Safety Suite Device Configurator (SSDC) to Set P2P Operation40
Connecting a Multirae to a PC to Enable Point-To-Point Operation44
Charging with the Multirae Desktop Cradle46
Automatic PID Cleaning47
Charging with the Travel Charger48
Carrying the Multirae in a Vehicle48
Charging with the Autorae 251
Replacing a Battery51
Charging Batteries with a Multirae Battery Charger52
Battery States54
Alkaline Battery Pack54
Turning the Multirae on and off57
Fast Access to Safety Suite Device Configurator (SSDC)57
Turning the Multirae on57
Turning the Multirae off58
Testing Alarm Indicators58
Glance Mode58
Pump Status59
Calibration Status60
Bump Status60
Toggle Display: Alternating between Correction Factor and Reading60
Enabling Benzene Operation & Sep-Tube Cartridge Tutorial61
Modes of Operation64
Hygiene Operation Mode64
Search Operation Mode64
Benzene-Specific Mode64
Basic User Mode71
Advanced User Mode71
Programming73
Enter Programming in Advanced Mode73
Enter Programming in Basic Mode74
Menus and Submenus75
Policy Enforcement119
Setting Policy Enforcement119
Deactivating Policy Enforcement123
Calibration and Testing126
Manual Alarms Test126
Bump Testing and Calibration126
Zero/Fresh Air Calibration131
Span Calibration132
Three-Point Calibration for Enhanced Linearity with Extended-Range and Ppb PID Sensors133
Multirae Pro Normal & Gamma Operation139
Normal Mode for Simultaneous Radiation & Gaseous Threat Measurements139
Gamma Radiation-Only Measurement Mode139
Via Computer143
Downloading Datalogs and Performing PC-Based Instrument Configuration and Firmware Upgrades144
Maintenance147
Removing/Installing the Rubber Boot147
Replacing the Filters148
Replacing the Gas Inlet Adapter149
Removing/Cleaning/Replacing Sensor Modules149
Removing/Cleaning/Replacing a PID (Pumped Versions Only)150
Replacing the Pump152
Alarms Overview154
Alarm Signals154
Changing the Alarm Mode154
Alarm Signal Summary155
Troubleshooting160
Pump Stall Threshold Adjustment164
Entering Diagnostic Mode to Set the Pump Stall Threshold164
Selecting the Pump Stall Threshold Method165
Setting Pump Stall Threshold Values - Dynamic Method165
Setting Pump Stall Threshold Values - Static Method167
Configuring Wi-Fi Communication171
Setting Wi-Fi Communication Parameters in Safety Suite Device Configurator (SSDC)171
Configuring Messaging176
Configuring BLE177
BLE Modes177
Specifications184

Honeywell MultiRAE Series - Page 45

Table of Contents

Related product manuals