Honeywell NOTIFIER APS2-6R/E User Manual

APS2-6R/E Instruction Manual — P/N 53232:B 2/26/2014 27
Panel Circuits UL 864 8th Edition Configurations
8. Attach battery interconnect cable.
B.7 Panel Circuits
All four (4) NACs (Notification Appliance Circuits) on the ICM and all four (4) on the ICE are powered from TB2
on the APS2-6R. The NACs share the total 6A available from that circuit. Auxiliary power harness (P/N 71091)
needs to have the header cut off and wired to the terminal block.
TB4
TB5
TB6
TB7
TB8
J9
XPIQ-PS Control Cable
XPIQ-PS Power
EXT TRBL IN
SW3
SW2
PHONE
1 AND 2
PHONE
3 AND 4
CHGTRBL
Phone 4 TRBL
Phone 3 TRBL
Phone 2 TRBL
Phone1 TRBL
Riser TR BL
TRBL
SPKR4
BATTRBL
A.C.Fail
J1
J2
Phone 1
Phone 2
Phone 3
Phone 4
Spkr4
TB9
2 X 2W
2 X 2W
1 X 4W
1 X 4W
+ OUT - SHLD
1 2 3 4 5 6
S - +
S - + S - + S - +
1 2 3
1 2 31 2 3
1 2 3 1 2 3
-
+
TB3
J9
-
+
-
+
TB4
JP4
J4
J3
JP2JP3
L
E
D
1
LED2
F
2
F
1
15
+ BATTERY -
AC GND NEUT HOT
CONTROL
INTERFACE
POWER FOR XPIQ-MB
F2
J2
J1
Note: Maintain 0.25” spacing between
Power-limited and Non-power-limited
wiring. Install tie wraps and adhesive
squares to secure the wiring.
APS2-6R
+ to battery
- back-up
Non-power-limited
xpiqaps26r.wmf
Figure B.7 Wiring to XPIQ
XPIQ-PS
XPIQ-MB
Non-power-limited
J65 J
J65 J
Note: Maintain 0.25” spacing between
Power-limited and Non-power-limited
wiring. Install tie wraps and adhesive
squares to secure the wiring.
APS2-6R
aps26ricm.wmf
Figure B.8 Wiring to an ICM/ICE Module
ICM
Non-power-limited
ICE
Power-limited
blue
blue
black
black
Auxiliary power harness
(P/N 71091)- cut off
header and attach to TB2

Honeywell NOTIFIER APS2-6R/E Specifications

General

Brand	Honeywell
Model	NOTIFIER APS2-6R/E
Category	Power Supply
Language	English