Honeywell NOTIFIER ID2000 Series - Page 18

ID2000 Series Operating Manual
Operator Actions at Panel
15 997-434-000-4, Issue 4
May 2010
System Test menu structure. The available
menus within this structure depend upon
the passcode and the panel configuration.
System tests are carried out using the menus on the
LCD display (see below).
To carry out a walk test of sensors or MCPs, select ‘0’
and see Section 4.8.1. To carry out a Control Output
test select ‘1’ (you will be asked for access passcode 3)
and see Section 4.8.2. To perform the daily or weekly
sensor automatic test select the appropriate pushbutton
(depends on the options available on the TEST menu)
and see Section 4.8.3.
The TEST menu also provides access to the VIEW
sensor function. VIEW sensors must be recalibrated after
replacement; select the appropriate pushbutton and see
Section 4.8.4.
TEST
ZONE WALK TEST
ZONE WALK TEST
CONTROL OUTPUT TEST
SENSOR AUTOMATIC TEST
REPLACE SENSOR
REPLACE SENSOR
TEST MODE: NETWORKED PANEL
TEST MODE: NETWORKED PANEL
TEST MODE: STAND-ALONE PANEL
TEST MODE: STAND-ALONE PANEL
CANCEL TEST MODE
CANCEL TEST MODE
CMX MODULES
CMX MODULES
SOUNDER 1
SOUNDER 1
SOUNDER 3
SOUNDER 3
SOUNDER 2
SOUNDER 2
LAMP TEST
SOUNDER 4
SOUNDER 4
SWITCH MODULE ON/OFF
SWITCH MODULE ON/OFF
SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF
DAILY AUTOMATIC TEST
WEEKLY AUTOMATIC TEST
REPLACE INDIVIDUAL SENSOR
REPLACE INDIVIDUAL SENSOR
SWITCH ON ALL LAMPS
SWITCH ON ALL LAMPS
REPLACE ENTIRE LOOP
REPLACE ENTIRE LOOP
RE-CALIBRATE SENSORS
RE-CALIBRATE SENSORS
RE-CALIBRATE SENSOR
RE-CALIBRATE SENSOR
CONTRAST