ID50 Series Panel - Installation, Commissioning & Configuration Manual
Configuration Mode
64
997-263-000-11, Issue 11
January 2010
6
5
[Setup] Primary Delay Time = 30 Seconds
Enter new value ____ : Confirm < : Cancel
[Setup] Primary Delay Time = 30 Seconds
Enter new value 300 : Confirm < : Cancel
2 Press the ‘
2
/
8
’ buttons to step through the Day/
Night Settings options until the Primary Delay Time
screen is displayed.
3 Press the ‘
6
’ button. The display then prompts you
for the new value:
4 Enter the required delay time using the numeric
buttons; (e.g. to set the delay time to the maximum
value of 300 seconds, first enter ‘3’, then enter ‘0’, ‘0’).
5 Press the ‘
5
’ button to confirm and return to the
Setup menu screen.
6 Repeat steps 1 to 5 for the Extend Delay Time, using
the Extend Delay Time display and a maximum value
of 10 minutes.
5
[Setup] Day mode activity = DISABLED
> : Change 1 : Disable ¦ : More < : Exit
To Next Page
Loading...
Need help?
General
