18 PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1
The PW-7000 DIP switches need to be set twice:
1. Configure the S4-S3-S2-S1 DIP switches to off-off-on-off to set the default
TCP/IP address to 192.168.0.251.
2. Apply power to the panel to set the IP address.
3. Change the S4-S3-S2-S1 combination to off-off-off-on. (DIP switch 1 is “read
on the fly”). This sets the login to the default user ID (“admin”) and password
(“password”) for Ethernet communications.
4. Create users. See User Configuration for instructions.
5. Set the S4-S3-S2-S1 combination to off-off-off-off.
6. Configure the host port(s) for IP Server and/or IP Client communications. See
Host Communication for instructions. This will enable both TCP/IP and serial
hardware networking when you log in again.
Factory Default Communication Parameters: Interface 1 (Port 0)
ON ON OFF OFF Unless the network administrator reserves an IP address for the panel (based on the
controller board’s Media Access Control (MAC) address), the PW-7000 uses
Dynamic Host Configuration Protocol (DHCP) to obtain an IP address from the
network DHCP server.
When power is applied with the switches in this position, there is a ten second
window (when LEDs 1and 2 flash alternately with LEDs 3 and 4), during which
memory is cleared if switch 1 or switch 2 is changed to OFF. When switch 1 or 2 is
changed to OFF, only LED 2 flashes and memory begins to be cleared. This period of
clearing lasts several minutes. When the memory has been cleared, the LED pattern
changes to the flashing of LEDs 1 and 4. The panel then reboots by itself. All data in
memory is erased except the serial number, MAC address, hardware revision, and
OEM code.
OFF OFF OFF ON DIP4 = ON -> Legacy Mode, PW7K1IC works as PW6K1IC.
DIP4 = OFF -> Native Mode, PW7K1IC Supported Functions and Capabilities,
Readers and IN/OUTPUTs on PW7K1IC can be used.
S1 S2 S3 S4 Selection
Network: static IP address
192.168.0.251
Subnet Mask: Default Gateway
255.255.0.0
Default Gateway
192.168.0.1
DNS Server
192.168.0.1
Primary Host port: IP server,
Data Security: TLS if Available,
port 3001, communication
address
0
Alternate Host Port Disable
To Next Page
Loading...
