Honeywell PW7K1IC - Run Time Supplying Power to the PW-7000 Interface; Wiring

22 PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1
Run Time Supplying Power to the PW-7000 Interface
Table 5 PW-7000 Status LED Combinations During Run Time
Wiring
This section presents information on reader wiring, input wiring, and control out-
put wiring. The following figure shows the PW-7000 board and identifies its termi-
nal block pin assignments.
LED Description
D1
Off-Line / On-Line and Battery Status
Off-Line = 20% On, ON-Line = 80% On
Double Flash means the Battery is Low
D2
Host Communication Activity (Ethernet port)
D3
Internal SIO Communication Activity
D4
External SIO Communication Activity
D5
Unassigned
D6
Reader 0:
Clock / Data or D1 / Do mode: Flashes when Data is
Received, Either Input F/2F Mode: Flashes when
Transmitting Data / Acknowledgment is Received Rs-485
Mode (OSDP): Flashes when Transmitting Data
D7
Reader 1:
Clock / Data or D1 / D0 Mode: Flashes when Data is
Received, Either Input F/2F Mode: Flashes when
Transmitting Data /Acknowledgment is Received RS-485
Mode (OSDP): Flashes when Transmitting Data
D8
Input IN 0 Status: OFF = Inactive, ON = Active, Flash = Fault*
D9
Input IN1 Status: OFF = Inactive, ON = Active, Flash = Fault*
D10
Input IN2 Status: OFF = Inactive, ON = Active, Flash = Fault*
D11
Input IN3 Status: OFF = Inactive, ON = Active, Flash = Fault*
D12
Input IN4 Status: OFF = Inactive, ON = Active, Flash = Fault*
D13
Input IN5 Status: OFF = Inactive, ON = Active, Flash = Fault*
D14
Input IN6 Status: OFF = Inactive, ON = Active, Flash = Fault*
D15
Input IN7 Status: OFF = Inactive, ON = Active, Flash = Fault*
D17
Relay K0: ON = Energizes, Door Relay
D18
Relay K1: ON = Energized, Door Relay
D19
Relay K2: ON = Energized
D20
Relay K3: ON = Energized
D23
Flashes with Ethernet Traffic