PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1 21
Initialization
1. Initialization: After power is applied or reset switch pushed, LED 1 is ON for
about 15 seconds, then LED's 2, 3, 4, 5, 6, R1, R2, IN0, IN1, IN2, IN3, IN4, IN5,
IN6, and IN7 are flashed once at the beginning of initialization.
2. LEDs 3 and 4 is turned ON for approximately 1 second after the hardware
initialization has completed, then the application code is initialized.
3. The amount of time the application takes to initialize depends on the size of the
database, about 1 second without a card database.
4. Each 10,000 cards will add about 2 seconds to the application initialization.
5. When LED's 1, 2, 3 and 4 flash at the same time, data is being read from or
written to flash memory.
Note: Do not cycle power when in this state.
6. If the sequence stops or repeats, perform the bulk erase procedure, see Bulk
Erase.
To Next Page
Loading...
