6 PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1
applications, single action exit without prior knowledge of what to do is a life safety
requirement. Always make certain that any required approvals are obtained in writ-
ing. DO NOT ACCEPT VERBAL APPROVALS SINCE THEY ARE NOT VALID.
Honeywell Integrated Security never recommends using the PW-7000 or related
products for use as a primary warning or monitoring system. Primary warning or
monitoring systems should always meet the local fire and safety code require-
ments.
Failure to test a system regularly could make the installer liable for damages to the
end user if a problem occurs.
Earth Grounding
Use Suppressors
UL/ULC Warnings
The following applies to installations that require UL or ULC compliance:
Only UL/ULC Listed readers with standard Wiegand data output communication
format (protocol) have been evaluated for use with this system.
This product is intended to be installed indoors, within the protected premises.
Access Control System, Model PW7000, and Controller, Model PW7K1IC meet the
requirements for CAN/ULC-S319-05 Equipment Class 1. This product's compli-
ance to ULC-S319, Electronic Access Control Systems, will be considered invali-
dated through the use of any add-on, expansion, memory or other module
manufactured or supplied by the manufacturer or manufacturer's representative,
unless specifically evaluated by ULC.
All unused conduit holes must be properly plated or incorporate a Listed plug to fill
any voids.
All interconnecting devices must be UL/ULC Listed.
Shielded cable shall be employed for all Input/Output wiring.
Warning: The earth ground is connected at the factory and should not be
removed.
Warning: AVERTISSEMENT: La prise de terre est reliée à l'usine et ne doit
pas être retirée
Warning: Use suppressors on all door strikes. Use S-4 suppressors for
installation. Honeywell Integrated Security, Inc. recommends
only DC strikes.
Warning: AVERTISSEMENT: Employer des suppresseurs de surtensions
transitoires (S-4) sur toutes les gâches de porte. Honeywell
Integrated Security recommande l'utilisation exclusive de
gâches électriques à courant continu.
To Next Page
Loading...
Need help?
General
