EasyManuals Logo

Honeywell PW7K1IC User Manual

Honeywell PW7K1IC
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
PW-7000 (PW7K1IC) Installation and Configuration Guide, Document 800-25673V1 7
Refer to the following Installation manuals for installation, connection, program-
ming, and operation instructions of the following sub-assemblies:
Note: Not Evaluated by UL for fire, life safety, or burglary applications.
Note: The earth ground is connected at the factory and should not be removed.
Do Not Connect To A Receptacle Controlled By A Switch.
Replacement 3 volt lithium coin cell must be one of the following:
Rayovac: BR2325 or BR2335-B
All interconnecting wire must be UL/ULC Listed, rated and suitable for the use.
The battery leads and primary AC main power wiring is non-power limited. This wir-
ing must be separated from all other wiring by at least 0.25" and cannot be
installed in the same conduit as any other power limited wiring.
The system must be configured to activate an alarm or trouble signal. Failure to do
so will not allow the access function to operate in the event of a tamper.
Note: The following applies to installations that require UL or ULC compliance:
Only UL/ULC Listed readers with standard Wiegand data output
communication format (protocol) have been evaluated for use with this system.
This product is intended to be installed indoors, within the protected premises.
Access Control System, Model PRO4200, and Controller, Model PRO42IC meet
the requirements for CAN/ULC-S319-05 Equipment Class 1.
This product's compliance to ULC-S319, Electronic Access Control Systems, will
be considered invalidated through the use of any add-on, expansion, memory or
other module manufactured or supplied by the manufacturer or manufacturer's
representative, unless specifically evaluated by ULC.
All unused conduit holes must be properly plated or incorporate a Listed plug to
fill any voids.
Assembly Number Installation Manual Part Number
PW7K1IC
800-25673
PW7K1R2
800-25676
PW7K1IN
800-25674
PW7KOUT
800-25675
PW6K1IC
800-00005V3
PW6K1R2
800-01951V4
PW6K1IN
800-01952V1
PW6K1OUT
800-01953V1
PW5K2ENC1 and PW5K2ENC2
800-06952
PW5K1ENC3
800-06955V1
PW5K2ENC5
800-08421
PW6K2E2PS
800-08279V3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell PW7K1IC and is the answer not in the manual?

Honeywell PW7K1IC Specifications

General IconGeneral
BrandHoneywell
ModelPW7K1IC
CategoryController
LanguageEnglish

Related product manuals