22 RP2/RP4 User Guide
Infrastructure/Ad-hoc
1. Open the NETira CT Printer Configuration Utility Tool and click on Tools -
Query Printer Configuration (or press CTRL-q) to query the printer.
2. Under Printer Information, click on WIFI.
3. Change (or confirm) the following parameter settings:
• ESSID: Type the name of your access point (Default = Honeywell)
• Network Type: Infrastructure or Ad-hoc
4. After updating the New Value column, ensure that the Include column
checkbox is selected for the values, and click the Send button to send this
change to the printer.
5. Allow 30 seconds for the printer to reset.
Wireless LAN Security
The printer can be configured to use several wireless LAN security protocols.
WEP 64 and 128 Bit
1. Open the NETira CT Printer Configuration Utility Tool and click on Tools -
Query Printer Configuration (or press CTRL-q) to query the printer.
2. Under Printer Information, click on WIFI.
3. Click on Static WEP.
4. Change (or confirm) the following parameter settings:
• WEP Selected Key: Select the key number to use
• WEP AP authentication: If users share 40 bit, use 64 bit encryption.
If users share 128 bit, use 128 bit encryption.
• WEP Data Encryption: Enable WEP Data Encryption
• WEP Key #1-4: Enter the WEP keys used by your access point
5. After updating the new values, ensure that the Include column checkbox is
selected for the values, and click the Send button to send this change to the
printer.
6. Allow 30 seconds for the printer to reset.
WPA2-PSK with CCMP
1. Open the NETira CT Printer Configuration Utility Tool and click on Tools -
Query Printer Configuration (or press CTRL-q) to query the printer.
2. Under Printer Information, click on WIFI.
3. Click on WPA/WPA2.
To Next Page
Loading...
