RP2/RP4 User Guide 55
Never attempt to charge when the printer case or printer is wet since a short circuit
could occur. Remove the printer from the case, allow to completely dry, and then
charge. In the event water is believed to have entered the printer, remove the bat-
tery and allow the unit to dry for several days before installing the battery or
charging.
USB On-the-Go
The RP2 or RP4 printer can act as a host so another device such as a barcode
reader, USB flash drive, or keyboard can be added. Contact your Sales Representa-
tive for a USB On-the-Go cable.
To Next Page
Loading...
