Honeywell SmartLine SLN 700 Series - 5 Operating the Transmitter; Functions of Keys; Figure 5-1: Instrument Panel 4-Key; Table 5-1: Keys of LCD

Revision 1 SLN 700 SmartLine NCR Level Transmitter User’s Manual Page 17
5 Operating the Transmitter
5.1 Functions of keys
There are 4 keys on the instrument panel, which can be used to operate the instrument. After
setup, the measurement value is displayed on the LCD screen and can be read out clearly
through the glass window. (SLN700 panel diagram)
Figure 5-1: Instrument panel 4-key
Table 5-1: Keys of LCD
Symbol Use Comment
Previous menu
• Exit the programming state;
• Back up to the upper menu;
• During operation, switch the measured
value/echo waveform.
Previous choice or change
number
• Modify the parameter value
• Select the display mode
Next choice or choose
digit.
• Select the programming item
• Select to edit the parameter
• Parameter item content display
Enter
• Enter the programming state
• Verify the programming item
• Confirm the parameter modification.