Honeywell SMV800 - Configuration Guide; Table 3 - Advanced Display Configuration

SmartLine Multivariable Transmitter
December 2015 Quick Start Installation Guide 19
CONFIGURATION GUIDE
Table 3 shows the transmitter display configuration.
Parameters in Italics are read-only.
* Applicable to HART only, not DE
Pressure Parameters
Common Parameters
Temperature Parameters
Flow Parameters
Table 3 – Advanced Display Configuration
Diagnostics
Critical
Active Diags
Meter Body
Meter Body Comm
Temp Sensor Board
Temp Input
Temp Sensor Comm
Comm Module
Comm VCC Fault
Non-Critical
Active Diags
Analog Out Mode
DP Zero Correct
DP Span Correct
Meter Body Input
Meter Body Temp
Meter Body Comm
Pressure Fac Cal*
Temp Cal Correct
Temp Module Temp
Temp Input Range
CJ Range
Temp Input
Temp Input TB6
Temp Fac Cal
Temp Comm
PV Out of Range
Supply Voltage
Comm Module Temp
DAC Temp Comp