Honeywell SMV800 - Mounting the Transmitter; Figure 2: Mounting Brackets

SmartLine Multivariable Transmitter
4 Quick Start Installation Guide December 2015
Available communication protocols are Honeywell Digitally Enhanced
(DE) and HART. Digital or Analog (4-20ma) output modes are available.
The SMV800 measures Process Temperature from an external RTD or
Thermocouple.
The device may be configured to map any of the four Process Variable to
the Analog Output (4-20 mA):
 Differential Pressure PV1
 Static Pressure PV2
 Process Temperature PV3
 Calculated Flow Rate PV4
MOUNTING THE TRANSMITTER
Transmitter models can be attached to a two-inch (50 millimeter) vertical
or horizontal pipe using Honeywell’s optional angle or flat mounting
bracket; alternately you can use your own bracket.
Typical Bracket mounted Installations
Figure 2: Mounting Brackets