Honeywell SMV800 - Page 21

SmartLine Multivariable Transmitter
December 2015 Quick Start Installation Guide 21
Calibration
Set Time Stamp*
Hour, Minute, Year, Month, Day
DP Zero Correct
Set Time Stamp*
Do DP Zero Correct
DP LRV Correct
Set Time Stamp*
Do DP LRV Correct
DP URV Correct
Set Time Stamp*
Do DP URV Correct
DP Reset Correct
Set Time Stamp*
Do DP Reset Correct
SP Zero Correct
Set Time Stamp*
Do SP Zero Correct
SP LRV Correct
Set Time Stamp*
Do SP LRV Correct
SP URV Correct
Set Time Stamp*
Do SP URV Correct
SP Reset Correct
Set Time Stamp*
Do SP Reset Correct
Temp Cal Points*
Temp Cal Lo Pt
Temp Cal Hi Pt
Temp Cal Lo Corr
Set Time Stamp*
Do Temp Cal Lo
Temp Cal Hi Corr
Set Time Stamp*
Do Temp Cal Hi
Temp Reset Corr
Set Time Stampv
Reset Temp Corr
DAC Trim
Trim Zero
Trim Span
Set DAC Normal
Loop Test
Set DAC Output
Set DAC Normal
* Applicable to HART only, not DE
Device Setup
Device Setup
Tag ID
Loop Source
NAMUR Output
HART Setup*
Device ID
Universal Rev
Field Device Rev
Final Assy Num
Loop mA
Poll Address
PV, SV, TV, QV Units
HART Date*
Year, Month, Day, Install Date,
Write Date
Dev Instl Date*
Year, Month, Day, Install Date,
Write Date
* Applicable to HART only, not DE