Honeywell SMX-AUS - About this Guide; Supplemental Documentation; Notice

Installation Guide SMX-AUS
NS-MN-0030 / 11.2020 7
2 Model: SMX-AUS Series Details
Panel Variants (SKU Number) Number of Loops Number of Devices Supported Address Range
915-200-103 1
Sensors: 99
1 - 99
Modules: 99
101 - 199
Total loop devices: 198
915-200-203 2
Sensors per loop: 99
1 - 99
Modules per loop: 99
101 - 199
Total devices per loop: 198
Total devices for 2 loops: 396
2.1 Replaceable Chassis Details
The panel chassis can be replaced. For more details, refer to chapter 7, “Replacing the Panel Chassis”.
Panel Variants (SKU Number) Replaceable Chassis Sub-assembly (SKU Number) Loop and Devices Support
915-200-103
315-650
This panel supports 1 loop and 198 devices
915-200-203
315-651
This panel supports 2 loop and 198 devices each
2.2 Specifications
Dimensions (L x B x H)
:
478 x 231 x 750 x (mm)
Operating temperature
:
0 … 40 °C
Color
:
Grey & Black
Relative Humidity
:
93 % ± 2 %.
Mounting Holes
:
4
Material
:
CRS
Knock outs
:
Top  25mm – 10 / 50mm - 5
IP Rating
:
IP30
:
Back  25mm – 2 / 50mm - 4
Operating Voltage
:
230 V AC, 50 / 60 Hz AC
:
Bottom  25mm – 2 / 50mm - 5
Stand-by Batteries
:
2 x 26 Ah
2.3 Standard Features
Following are the standard features of the fire alarm control panel according to AS 7240.2-2004:
5.5
Battery function check according to AS 7240.4-2004
7.12.2
Dependencies on more than one alarm signal (Type B)
7.8
Output to fire alarm devices
7.12.3
Dependencies on more than one alarm signal (Type C)
7.9.1
Output to fire alarm routing equipment
8.0
Supervisory Signal Condition
7.9.2
Alarm confirmation input from fire alarm routing equipment
9.3
Fault signals from points
7.10.2
Outputs to fire protection equipment (Output Type B)
9.9
Output to fault warning routing equipment
7.10.4
Fault monitoring of fire protection equipment
10.0
Disablement Condition
7.11
Delays to outputs
10.5
Disablement of each addressable points
7.12.1
Dependencies on more than one alarm signal (Type A)
11.0
Test condition