EasyManua.ls Logo

Honeywell SMX-AUS - Standards and Downloads; Standards; Software Downloads; Documentation Feedback

Honeywell SMX-AUS
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation Guide SMX-AUS
8 NS-MN-0030 / 11.2020
2.3.1 Programmable Features/Settings
Following are some of the features of the fire alarm control panel:
Connections to one or two Signaling Line Circuit (SLC) loops (CLIP protocol) Onboard monitored input for supervisory
Onboard alarm, fault, and programmable relays Set date and time
Multi-color touch screen display
Walk test - with all sounders / one selective sounder / without any
sounder options
RS485 connections for wiring annunciators Point, Zone, Logic Zone, Output Group Disablements and
programmable Relay
RS232 connection for printer Alarm Delay Facility (ADF) and Alarm Verification Facility (AVF)
Firmware upgrade or downgrade through USB Up to 4 Fire Fan Control groups using SLC loop modules, along with
duct detector support and Fire Fan Control Panel (FFCP) on fascia
Portable configuration settings (through USB or Bluetooth) Occupant Warning System (OWS) support
Backing up the event logs (through USB or Bluetooth) Door MCP for fire alarm
Multi-level access control (Level 1, 2, 3, and 4)
Add-on Relay I/O Card with Alarm Routing Equipment interface and
one programmable Relay
All sounder deactivation via programming 160 programmable zones (system-wide)
Auto-learning capability 100 logic zones with AND, OR, NOT logic conditions
Configuration options: USB storage device, mobile app, and the panel interfaces Non-latched supervisory action for detectors and modules
10,000 event logs for SMX-AUS Configurable alarm sensitivity levels for smoke and multi sensors
View pulse width (PW) values Fire-Trip latching for relays and control modules, until Fire Mode Reset
View voltage and analogue values Integration to external systems using printer port
2.4 System Components
Power supply:
A 230 V AC power supply is the main source of power and has power backup provision, which can accommodate 2 batteries with 26 Ah capacity for both 1-loop and
2-loop panels.
Tolerance: 220 V - 240 V AC
Frequency: 50 / 60 Hz
Fuse Rating: 5 A / 250 V

Other manuals for Honeywell SMX-AUS

Related product manuals