16 796689 (4188-658) i2_04/07
Fire Test
To enter fire test
mode
A2
Test
The system 800 panel has a fire test facility,
which puts all the zones into test mode and
recommends which manual call point is to
be fire tested next.
In Test State all normal fire
detection functions are disabled.
Enter access level 2.
Press Enter to display the top-level
menu.
From the System menu select Fire Test
option and press Enter to accept the
selection.
Press Enter to enter Fire test.
Now carry out a Fire Test on the
recommended manual call point and notice
the alarms are only active for a short
duration. On completion exit test state.
To Next Page
Loading...
Need help?
General
