Honeywell Tema-Voyager Compact - Clocking in and Clocking out

19
CLOCKING IN AND CLOCKING OUT
Clocking in and clocking out
In the T&A application, “Clock in” and “clock out” are terms that refer to the
direction of a transit.
Clock in indicates the time you enter the office (the clock starts counting the time
the cardholder is in the office).
Clock out indicates the time you leave the office (the clock stops counting the
time).
A Voyager device can be configured for one direction (clock-in OR clock-out), or
for both directions (clock-in AND clock-out).
In this case, to set a specific direction for the device you must use the “Change
direction” function.
To change the transit direction and perform the transit:
1 Check the current direction set for the terminal that is shown on the right side
of the header of the display.
2 Select the Change direction icon on the toolbar and click Enter. The direction
of the terminal in the header line of the display will change.
3 Present your card to the device.
Figure 9 Change Transit Direction display