LCN System Installation 3-7 9/96
3.5.1
3. Place the second station next to the first station.
4. Insert a Flexible Spacer, Bottom Arc, 51308033-100, between the two lower
monitors as shown in Figure 3-5. The spacer fits in the groove behind the bezel,
on both stations, with the top even with the middle of the CRT Mount (wedge.)
5. Upper Monitors:
• If there is an upper monitor in both stations, and they are tilted forward, insert a
Flexible Spacer, Bottom Arc, 51308033-100, between the two upper monitors.
The spacer fits in the groove behind the bezel. See Figure 3-5.
• If there is an upper monitor in both stations, and they are
not tilted forward,
insert a Flexible Spacer, Top Arc, 51308036-100, between the two upper
monitors. The spacer fits in the groove behind the bezel. See Figure 3-6.
In both cases, the top insert must be tight to the insert below it. Trim the excess
upper end of the Flexible Spacer.
12557
Figure 3-5 — Arc Complexed Ergonomic Universal Stations with Wedges
To Next Page
Loading...
