LCN System Installation 3-6 9/96
3.5
3.5 CONSOLE COMPLEXING—ERGONOMIC UNIVERSAL STATION
FURNITURE
Ergonomic US furniture can be complexed in two forms.
• A semicircular arc, where each station is arced 10° from the adjacent station, is
formed by bolting the stations together. See Figure 3-4.
• A inline console where wedges are added in between each station to close the gaps
left between the front surfaces. See Figure 3-5.
3.5.1 Complexing for an Arced Configuration
The following steps are required for the joining of two stations together. The complexing
tie plates (2) are attached to one station, the second station is set in place next to the first,
the flexible spacers are inserted, and then the second station is bolted to the two tie plates.
1. Install a Wedge Tie Plate Arc, 51403114-100, to the front of the bottom corner of
one of the two stations bases. See Figure 3-4.
2. Install a Tie Plate Arc, 51308037-100, under the keyboard of the same station.
Install
51403114-100 (ARC)
51403124-100 (INLINE)
Install
51308037-100 (ARC)
51308056-100 (INLINE)
12556
Figure 3-4 — Arced Complexed Universal Stations
To Next Page
Loading...
