LCN System Installation 14-5 9/96
14.10
14.10 CONNECTION TO PRINTER
ESD Wrist Strap
Use ESD
Wrist Strap
Use an ESD Wrist Strap grounded to the Minitower chassis when
connecting or disconnecting cables.
A single laser or matrix printer can be connected to the PARALLEL port on the rear panel
of the minitower. A laser printer can be placed on an adjacent work surface. If a Signum
printer is used, it must be placed on a pedestal or other supporting device.
STOP! Do not proceed until you have completed the configuration function detailed in
the Configurator. The LCN node number is software-configured and may conflict with
another node until it is correctly configured. If you proceed to connect the LCN cables,
parts of the LCN can become ISOLATED.
To Next Page
Loading...
