Honeywell TotalPlant LCN - Connecting the Optional Integrated Keyboard and Mouse; Connecting the Optional Touchscreen; Connection to the Ethernet

LCN System Installation 14-4 9/96
14.7
ESD Wrist Strap
Use ESD
Wrist Strap
Use an ESD Wrist Strap grounded to the Minitower chassis when
connecting or disconnecting cables.
14.7.2 Connecting the Optional Integrated Keyboard and Mouse
1. Connect the 15-pin cable connector to the Keyboard connector (right-hand) on the face
plate of the left-most ISA card slot.
2. Connect the Mouse Cable 9-pin connector to the Mouse miniature DIN connector on the
rear of the minitower.
3. Connect the jumper cable, 51305381-100, to the IKBI2 board in slot 5 (left-most slot)
and to the rear panel connection labeled “KB.”
16222
IKB
Curso
r
IKBI2
Mother
Board
Mouse
MiniTower
IKBI PS/2 KB Cable
51305381-100
KB
Keyboard
Interface
Figure 14-2 — Integrated Keyboard/Mouse Cable Connections to Rear Panel
14.8 CONNECTING THE OPTIONAL TOUCHSCREEN
Connect the free end of the touchscreen cable to the connector in Slot 4 (second slot from
the left).
14.9 CONNECTION TO THE ETHERNET
An adapter, 51191782-100, is connected to the Ethernet connector on the back of the
electronic tower. This adapter connects to the 10base-5 Ethernet or a 10base-2 Ethernet.
If a 10base-T Ethernet is used, the cable from the hub is connected to the RJ-45 connector
on the rear panel.