LCN System Installation 14-3 9/96
14.4
14.4 GROUNDING
The Deskside Global User Station is grounded to safety ground by the third wire in the
power cord.
14.5 AC POWER
Connect the ac power cords attached to the module and monitor to an ac power outlet that is
connected to the same power source as the rest of the TotalPlant Solution (TPS) System. If
the unit is to be used for a window to a process, it is recommended that the ac power outlet
is connected to the power circuits from an Uninterruptible Power Source (UPS). This will
prevent loss of unsaved data in the event of a power outage.
14.6 CONNECTING THE MONITOR
ESD Wrist Strap
Use ESD
Wrist Strap
Use an ESD Wrist Strap grounded to the Minitower chassis when
connecting or disconnecting cables.
Connect the 17-inch monitor interface cable to the SVGA connector on the back of the
electronic tower. Connect the other end of the cable to the back of the monitor.
Connect the 21-inch monitor interface cable, 51192126-400, to the SVGA connector on the
back of the electronic tower. Connect the other end of the cable to the back of the monitor.
Connecting a dual monitor requires that both monitors be connected to the dual monitor
card located in slot 1 (right-hand slot). The primary monitor connects to the top connector
and the secondary connects to the bottom connector.
14.7 CONNECTING THE KEYBOARD
There are two keyboard types available:
• Standard PC keyboard
• Optional Integrated Keyboard, 51196694-300
14.7.1 Connecting the Standard Keyboard
Connect the free end of the keyboard interface cable to the KEYBOARD connector on the
back of the electronics tower.
To Next Page
Loading...
