LCN System Installation 11-1 9/96
11
RULA INSTALLATION
Section 11
Provides for the installation of a Remote User Link Adapter (RULA) in a Universal Station,
Operator Interface Station (OIS), Micro TDC 3000, and Universal Work Station.
11.1 INSTALLATION INSTRUCTIONS
In general, the Dayna SCSI/Link—3 unit is installed on the support tray in a half height
upper pod next to a Cartridge Drive. There must be an existing cartridge drive installed.
• The old power cable for the cartridge drives is disconnected and a new cable that
has an addition connector to provide power to the Dayna SCSI/Link—3 module, is
connected to the old cable. The old cable connection is then re-established.
• The old SCSI Interface Cable for the cartridge drives is disconnected and a new
cable that has an additional connector to provide connection to the Dayna
SCSI/Link—3 module, is connected to the old cable. The old cable connection is
then re-established.
• The Dayna SCSI/Link—3 adapter is mounted to a support bracket with hook and
loop fastener strips.
• The Ethernet connection is now ready to be made.
Detailed instructions for the four applications are found in two places:
• Upgrade Kit Index UK20-100
• Individual copies are included in the shipment of the hardware.
The four kits are:
• MP-RLKT11 Universal Station applications
• MP-RLKT12 Micro TDC 3000 applications
• MP-RLKT13 Operator Interface Station applications
• MP-RLKT14 Universal Work Station applications
To Next Page
Loading...
