LCN System Installation 3-12 9/96
3.6
3.6 LCN CABLING
As shown in Figure 2-2, LCN cabinets have the intracabinet cables installed in the factory.
The system is then tested in a system configuration and the cables inside the cabinet are left
in place to be shipped with the equipment. The remaining installation task is for the
cabinets and the consoles to be cabled together as shown in Figure 3-9, Figure 3-10, and
Figure 3-11.
Rear View
Coax Connection
to LCN System
Cable A
Cable B
Cable A
Cable B
53851
Rear View
Figure 3-9 — Intracabinet Coax Cabling between LCN Cabinets
After the Universal Stations have been complexed (bolted) together, coax cable can be
connected as shown in Figure 3-10 or Figure 3-11. Cables can exit and enter each US
through the bottom or through the side openings.
To Next Page
Loading...
