LCN System Installation 3-20 9/96
3.9
5. The peripheral cables are folded and retained by cable clamps inside the
worksurface cabinet.
For Classic furniture
• Unfasten the cable, still passing them through the cable clamp.
• Pass the cable through the cable pass-through hole in the
cabinet side, into the Universal Station (or Universal Station
X
)
cabinet.
• Connect the peripheral interface cable as follows:
– Cartridge cable, 51192054-102 to the EPDGC or TPDGC
I/O board SCSI connector J2.
For Ergonomic furniture
• The cables are stored in the foot of the worksurface furniture.
Free the cable and pass the cable through the cable pass-through
hole in the cabinet side, into the Universal Station (or Universal
Station
X
) cabinet.
• Run the interface cable up the left side of the console leg to the
I/O card file.
• Connect the peripheral interface cable(s) as follows:
– Cartridge cable, 51192054-102 to the EPDGC or TPDGC
I/O board SCSI connector J2.
6. If there is any excess cable hanging below the cabinet, pull it into the single bay
cabinet and fasten it in the cable clamps on the side of the cabinet.
To Next Page
Loading...
