Honeywell VARIODYN D1 - 4 XD and 4 XV Series Specifications

Installation Instruction VARIODYN
®
D1 System
FB 798663.GB0 / 05.19 71
7.6.2 Specification - 4XD and 4XV-Series
Type 4XD125B 4XD250B 4XD300 4XD500 4XV300 4XV500
Mains voltage : 230 V AC, +10% / -5%
Frequency range : 50 … 60 Hz
Emergency
power supply
: 21,5 V DC … 28,5 V DC 24 V DC --- ---
Rated current
@ 230 V AC
*6
: 1,13 A 2,2 A 4,0 A 6,0 A 4,0 A 6,0 A
Rated current
@ 24 V DC
*6
:
9,44 A 18,6 A 25,9 A 40,1 A --- ---
Current
(1 kHz sinus / 1 min.)
@ 24 V DC
*7
: 26,5 A 53,5 A 57,0 A 83,0 A --- ---
Output power
*8
: 4 x 125 W 4 x 250 W 4 x 300 W 4 x 500 W 4 x 300 W 4 x 500 W
Technology : Class D
Transmission range :
20 … 22 kHz 20 Hz … 20 kHz
Input level : 0 dBu
System input
impedance
:
20 kOhm
Signal to noise ratio :
≥ 90 dB (A) ≥ 97 dB (A)
Channel separation : ≥ 75 dB ≥ 83 dB
Distortion factor
@ 1 kHz
:
≤ 0,3 % ≤ 0,05 %
Efficiency : ≥ 80 %
Ambient
temperature
: -5 °C … +55 °C
Storage
temperature
:
-10 °C … +55 °C
Humidity :
up to 93 % rel. hum. (non-condensing)
Housing :
Metal
Colour :
grey, similar to RAL 7016
Weight :
approx. 9 kg approx. 12 kg approx. 14,3 kg approx. 14,4 kg approx. 13,4 kg approx. 13,5 kg
Dimensions
(w x h x d)
:
483 x 44 x 400
mm (1HU)
483 x 88,4 x 390 mm (2 HU)
Specification : EN 54-4 and EN 54-16
*6
Rated current @ 33 % load
*7
Acc. EN 54-16 (laboratory test)
*8
Output power acc. EN 54-16.
For analogue amplifiers, the output power is generally used as the planning dimension.
This is not always possible for digital final stages. If there are no details relating to
amplifier/loudspeaker pairings for specific signals, a maximum of 50 % of the nominal power should
be used as the planning dimension.