5 - 4
LED Flash Rate
If you have silenced the scanner’s beeper, you may set the how quickly the LED flashes when reading bar codes. Default =
Fast Flash.
LED Solid (No Flash)
If you have silenced the scanner’s beeper, you may set the LED to remain on when reading bar codes instead of flashing.
Default = LED Solid Off.
Paging Volume Control
When you press the Page button on the base or Access Point, the scanners associated with that base or Access Point will
begin beeping in response. If you pull the trigger on a scanner that is beeping in response, or press the Page button on the
base or Access Point a second time, all associated scanners will stop beeping. The following settings set the paging vol-
ume, independent of the volume used when scanning bar codes. Default = Low.
To Next Page
Loading...
