Honeywell Xenon 1910 - Connecting with RS485

1 - 8
Connecting with RS485
A Xenon scanner or cordless base can be connected for an IBM POS terminal interface. (This interface is not available in
the Granit devices.)
1. Connect the appropriate interface cable to the device, then to the computer.
Note: The power supply must be ordered separately, if needed.
2. Make sure the cables are secured in the wireways in the bottom of the cordless base and the base sits flat on a
horizontal surface.
3. Turn the terminal/computer power back on. The scanner beeps.
4. Verify the scanner or cordless base operation by scanning a bar code from the Sample Symbols in the back of this
manual. The scanner beeps once. If using a Granit scanner, it also vibrates.
For further RS485 settings, refer to RS485, page 2-2.
Corded Xenon Scanner
RS485 Connection:
CCB01-010BT Base
RS485 Connection: