12 - 4
Menu Commands
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page
Product Default Settings
Setting Custom Defaults Set Custom Defaults MNUCDP 1-13
Save Custom Defaults MNUCDS 1-13
Resetting the Custom Defaults Activate Custom Defaults DEFALT 1-13
Resetting the Factory Defaults -
cordless scanners
Factory Default Settings:
All Application Groups
PAPDFT& 3-20
Resetting the Custom Defaults -
cordless scanners
Custom Default Settings:
All Application Groups
PAPDFT 3-21
Programming the Interface
Plug and Play Codes Keyboard Wedge:
IBM PC AT and Compatibles with
CR suffix (not supported by Granit
1980i)
PAP_AT 2-1
Laptop Direct Connect with CR
suffix (not supported by Granit
1980i)
PAPLTD 2-1
RS232 Serial Port PAP232 2-1
Plug and Play Codes:
RS485
IBM Port 5B Interface PAPP5B 2-2
IBM Port 9B HHBCR-1 Interface PAP9B1 2-2
IBM Port 17 Interface PAPP17 2-2
IBM Port 9B HHBCR-2 Interface PAP9B2 2-2
RS485 Packet Mode On RTLPDF1 2-2
RS485 Packet Mode Off RTLPDF0 2-2
RS485 Packet Length (20-256) RTLMPS 2-3
Plug and Play Codes: IBM SurePos USB IBM SurePos Handheld PAPSPH 2-3
USB IBM SurePos Tabletop PAPSPT 2-3
Plug and Play Codes: USB USB Keyboard (PC) PAP124 2-3
USB Keyboard (Mac) PAP125 2-3
USB Japanese Keyboard (PC) TRMUSB134 2-3
USB HID PAP131 2-4
USB Serial TRMUSB130 2-4
CTS/RTS Emulation On USBCTS1 2-4
CTS/RTS Emulation Off* USBCTS0 2-4
ACK/NAK Mode On USBACK1 2-4
ACK/NAK Mode Off* USBACK0 2-4
Remote MasterMind for USB ReM Off REMIFC0 2-4
ReM On REMIFC1 2-4
To Next Page
Loading...
