8 - 1
8
Symbologies
This programming section contains the following menu selections. Refer to Chapter 12 for settings and defaults.
All Symbologies
If you want to decode all the symbologies allowable for your scanner, scan the All Symbologies On code. If on the other hand,
you want to decode only a particular symbology, scan All Symbologies Off followed by the On symbol for that particular sym-
bology.
Note: When All Symbologies On is scanned, 2D Postal Codes are not enabled. 2D Postal Codes must be enabled separately.
Message Length Description
You are able to set the valid reading length of some of the bar code symbologies. If the data length of the scanned bar code
doesn’t match the valid reading length, the scanner will issue an error tone. You may wish to set the same value for minimum
and maximum length to force the scanner to read fixed length bar code data. This helps reduce the chances of a misread.
• All Symbologies • Interleaved 2 of 5
• Aztec Code • Korea Post
• China Post (Hong Kong 2 of 5) • Label Code
• Chinese Sensible (Han Xin) Code • Matrix 2 of 5
• Codabar • MaxiCode
• Codablock A • MicroPDF417
• Codablock F • MSI
• Code 11 • NEC 2 of 5
• Code 128 • Postal Codes - 2D
• Code 32 Pharmaceutical (PARAF) • Postal Codes - Linear
• Code 39 • PDF417
• Code 93 • GS1 DataBar Omnidirectional
• Data Matrix • QR Code
• EAN/JAN-13 • Straight 2 of 5 IATA (two-bar start/stop)
• EAN/JAN-8 • Straight 2 of 5 Industrial (three-bar start/stop)
• GS1 Composite Codes • TCIF Linked Code 39 (TLC39)
• GS1 DataBar Expanded • Telepen
• GS1 DataBar Limited • Trioptic Code
• GS1 DataBar Omnidirectional • UPC-A
• GS1 Emulation • UPC-A/EAN-13 with Extended Coupon Code
•GS1-128 •UPC-E0
•UPC-E1
To Next Page
Loading...
