3 - 23
Virtual Keyboard
Once your scanner has been connected directly to an iPad, smart phone, or laptop, you can toggle the virtual keyboard on
your device with a quick double pull of the scanner trigger.
Note: This feature is not supported in Granit devices.
Bluetooth HID Keyboard Disconnect
If your scanner has been connected directly to an iPad, smart phone, or laptop using Bluetooth HID Keyboard Connect
(page 3-22), you must disconnect it in order to once again communicate with the base or Access Point. Scan the Blue-
tooth HID Keyboard Disconnect bar code to unlink the scanner from the currently linked host. Scan the linking bar code
on the base or Access Point to relink the scanner.
Bluetooth Serial Port - PCs/Laptops
Scanning the Non-Base BT Connection bar code below allows the scanner to be used with other Bluetooth devices (e.g.,
PC/laptop). When in this mode, the scanner behaves like an RS-232 serial device, and you will need to open a COM port
on the host to read scanned data.
After you scan the bar code below, follow the instructions supplied with your Bluetooth device to locate the scanner and
connect to it. If you go out of range with your scanner, the scanner will not reconnect to the Bluetooth device when it is back
in range. If you want to relink to the charge base or Access Point, refer to Override Locked Scanner, page 3-11.
Note: The multiple work groups option is not available when you are using the scanner with Bluetooth devices other than
the charge base or Access Point.
Bluetooth HID Keyboard Disconnect
To Next Page
Loading...
