5 - 5
Out-of-Range Alarm Volume
If your scanner is out range of the base, an alarm sounds from both your base and scanner. If your scanner is out range of
an Access Point, an alarm sounds from just the scanner. The alarm stops when the scanner is moved closer to the base or
Access Point, when the base or Access Point connects to another scanner, or when the alarm duration expires (see Out-of-
Range Delay on page 5-6). The following settings set the Out-of-Range Alarm for the base and the scanner, independent
of the volume used when scanning bar codes. Default = Base Alarm Volume Low, Scanner Alarm Volume Low.
* Scanner Alarm Volume
Low
Scanner Alarm Volume
Medium
To Next Page
Loading...
