4 - 13
2D Reread Delay
Sometimes 2D bar codes can take longer to read than other bar codes. If you wish to set a separate Reread Delay for 2D
bar codes, scan one of the programming codes that follows. 2D Reread Delay Off indicates that the time set for Reread
Delay is used for both 1D and 2D bar codes. Default = 2D Reread Delay Off.
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the Character Activation Timeout (page 4-14), the deactivation character is received
(see Deactivation Character on page 4-15), or a bar code is transmitted. Scan the following On bar code to use character acti-
vation, then use Activation Character (following) to select the character you will send from the host to start scanning. Default =
Off.
To Next Page
Loading...
Need help?
General
