12 - 8
7 Data, 1 Stop, Parity None 232WRD0 2-20
7 Data, 1 Stop, Parity Odd 232WRD6 2-20
7 Data, 2 Stop, Parity Even 232WRD4 2-20
7 Data, 2 Stop, Parity None 232WRD1 2-20
7 Data, 2 Stop, Parity Odd 232WRD7 2-20
8 Data, 1 Stop, Parity Even 232WRD5 2-20
*8 Data, 1 Stop, Parity None 232WRD2 2-20
8 Data, 1 Stop, Parity Odd 232WRD8 2-20
8 Data, 1 Stop, Parity Mark 232WRD14 2-20
RS232 Receiver Time-out Range 0 - 300 seconds 232LPT### 2-20
RS232 Handshaking *RTS/CTS Off 232CTS0 2-21
Flow Control, No Timeout 232CTS1 2-21
Two-Direction Flow Control 232CTS2 2-21
Flow Control with Timeout 232CTS3 2-21
RS232 Timeout 232DEL#### 2-21
*XON/XOFF Off 232XON0 2-22
XON/XOFF On 232XON1 2-21
*ACK/NAK Off 232ACK0 2-22
ACK/NAK On 232ACK1 2-22
Scanner-Bioptic Packet Mode *Packet Mode Off 232PKT0 2-22
Packet Mode On 232PKT2 2-22
Scanner-Bioptic ACK/NAK Mode *Bioptic ACK/NAK Off 232NAK0 2-22
Bioptic ACK/NAK On 232NAK1 2-23
Scanner-Bioptic ACK/NAK Timeout ACK/NAK Timeout
*5100
232DLK##### 2-23
Cordless System Operation
Note: This section applies only to cordless systems. It does not apply to corded scanners.
Base Power Communication
Indicator
*On :*:BASRED1 3-6
Off :*:BASRED0 3-6
Reset Scanner Reset Scanner RESET_ 3-6
Scanning While in Base Cradle Scanning in Cradle Off BT_SIC0 3-6
*Scanning in Cradle On (CCB01-
010BT default)
BT_SIC1 3-6
Shut Down Scanner in Cradle BT_SIC2 3-6
Base Charging Modes Base Charge Off BASCHG0 3-7
*External or Interface Cable Power BASCHG1 3-7
External Power Only BASCHG2 3-7
Paging Mode *On BEPPGE1 3-7
Off BEPPGE0 3-7
Paging Pitch Range 400 - 9000 Hz (*1000) BEPPFQ#### 3-7
Beeper Pitch - Base Error *Razz (250) (min 200Hz) BASFQ2250 3-8
Medium (3250) BASFQ23250 3-8
High (4200) (max 9000Hz) BASFQ24200 3-8
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page
To Next Page
Loading...
